What is the scope of a photovoltaic system?

The scope includes all parts of the PV array up to but not including energy storage devices, power conversion equipment or loads. The object of this Technical Specification is to address the design safety requirements arising from the particular characteristics of photovoltaic systems.

What parts of a PV array are covered?

The scope includes all parts of the PV array up to but not including energy storage devices, power conversion equipment or loads. An exception is that provisions relating to power conversion equipment are covered only where DC safety issues are involved.

What are the installation requirements for a PV array?

Installation requirements are also critically dependent on compliance with the IEC 60364 series (see Clause 4). PV arrays of less than 100 W and less than 35 V DC open circuit voltage at STC are not covered by this document. PV arrays in grid connected systems connected to medium or high voltage systems are not covered in this document.

What are the technical aspects of a PV power plant?

Technical areas addressed are those that largely distinguish PV power plants from smaller, more conventional installations, including ground mounted array configurations, cable routing methods, cable selection, overcurrent protection strategies, equipotential bonding over large geographical areas, and equipment considerations.

What are the requirements for regulating PV system design and battery function?

First, to regulate system design and battery function: IEC 62124 for stand-alone PV system design recommendations and PV performance evaluation (including battery testing and recovery after periods of low state-of-charge) in a variety of climatic conditions, and IEC 62509 for battery charge controllers.

What are the regulatory levels for photovoltaic systems?

At least three regulatory levels for the production, installation, operation and end of life of photovoltaic systems can be considered. Additionally, the Life Cycle Assessment methodology is also regulated by standards. In this chapter, the three levels are presented.